Silicone grip dots for textiles: where the grip comes from
Diameter, height, pitch and hardness; four application profiles for pads, cuffs, insoles and cushions.
Read moreApplications
One industry, one part: what duty it lives in, why silicone is used, where it fails first, and what to check in design and validation.
Application articles
8 articles, newest first.
-
-
Silicone dots on elastic: pattern design under stretch
Why a flat array stops gripping once worn; pre-compensation, bars and transfer film.
Read more -
Medical Silicone Patches: Skin Contact and Wear Limits
Four layers, not one sheet: gel, carrier, functional layer and liner — wear time decides the material, thin-wall limits decide the tooling.
Read more -
Drone Gimbal Dampers: Four Silicone Balls and Image Stability
Isolation is a frequency problem, not a softness contest: four-point consistency, temperature effects, ageing, and the five parameters to fix before ordering.
Read more -
Foam or Perforated Silicone? Helmet Liners and Insoles
Airflow, impact, heat, weight, odour and washability compared, where foam still wins, and the three design changes a switch requires.
Read more -
EV Charging Gun Seals: Condensation, Mating and Heat
Breathing drawing moisture in, mating wear thinning the face seal, current heat speeding compression set, and which material belongs where.
Read more -
Silicone Overmolding in Floor Washers: Water, Hair, Vacuum
Why detergent leaks where water will not, how vacuum deforms gaskets, hair wearing the lip, and material assignment and tests.
Read more -
The gasket inside a drill: why power-tool seals wear out
Trigger boot, output-shaft lip seal and battery interface: dust is an abrasive, grease plus grit becomes a grinding paste, and which material goes where.
Read more -
The seal in a toothbrush handle: why IPX7 still leaks
Four soft parts in a powered toothbrush, three leak paths IPX7 does not cover, and why the grip is usually TPE rather than silicone.
Read more -
Espresso machine gaskets: why they fear oil, not heat
Four seals and four duty conditions: coffee oil, milk fat and alkaline backflush, plus how silicone compares with EPDM and FKM.
Read more